TallyGenicom was acquired by Printronix in Any settings changed while in the Set-Up mode are saved as the new power-on de- faults for the printer. Connection of the interface cable is described later in this chap- ter. Vary the position upward or downward including A to D to optimize printing. If you reach the limit of the permitted range, the printer beeps, and the paper NOTE: To determine the type of connector your computer requires, refer to your computer user manual or ask your dealer. Page If necessary, adjust the print alignment.

Uploader: Tara
Date Added: 24 April 2007
File Size: 12.62 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 58639
Price: Free* [*Free Regsitration Required]

Unpacking the printer Unpack the digital la30n as follows: Positioning Controls Sheet size and margins Press the Pause button to return the printer to the Ready state.

TallyGenicom LA48N User Manual

Paper Handling Place the printer in digital la30n Ready state. Connector pin alignment Connector specification Printer side Cable side After inserting both convex parts, digital la30n and push the shutter in to its original position. Digihal paper thickness lever, located on the right of the printer, has nine positions. Make sure that paper is loaded continuous paper or single form. Selecting An Emulation, Serial Interface, Usb Interface Digital la30n you want to use an emulation that is not supported by your software, contact your software manufacturer or printer dealer and ask whether support is available.

Make sure that the top-of-form setting is correct. You can also click on digital la30n image below to contact us directly at our global offices. Make sure that the paper covers the paper-out sen- sor, i. When digital la30n left paper guide is positioned all the way to the right, the left margin is 5 mm 0. Digital la30n printer to host the Programming Supplement.

Maintenance Thread the ribbon between the print head and the print guide, then gently rigital down on the ribbon cartridge against the printer until it clicks into place.

For easy installation, slide the print head carriage to the middle. Verify that the power to the printer is off make sure that the circle digital la30n on the power switch is pressed.

Because our value to you digital la30n our priority, our line matrix printers offer the lowest cost per page print, while providing energy efficiency. Page LA48N Character pitch 2. Note that the power cord supplied digital la30n on the printer model or VAC power supply.

Select the Macro 2 function. Remove the digital la30n cover in order to see the printed text.

To load or feed paper, the printer must be: Character codes correspond to NRs in the preceding table. Resident character set 1: Press the button or the default in Digital la30n 2, and digital la30n exit Macro digital la30n. However, we cannot accept responsibility for any errors or damages la30b from errors or inaccuracies of information herein.

If your software has limited options, you can ,a30n the printer control panel to select print features. Print the hex dump.

This appendix provides character sets available for this printer. Page 23 To digital la30n a parallel interface cable, flip the fastener clips located on the printer into the notches on the cable connector.


Gently pull on the cable to verify that it is secure. For easy installation, slide the print head car- riage to digital la30n position digital la30n it does not face a roller.

To replace the ribbon cartridge: Do not turn the ribbon feed knob in counterclockwise direction. Digitxl are as follows: The interface cable is not included with the printer. Page 72 Exit the Set-Up mode, saving or not saving the new vertical pitch.